Archive for November, 2009

2010 Ford Mustang Burnouts & More – Exclusive First Drive

admin November 23rd, 2009

InsideLineVideo asked:


SEE THE EXCLUSIVE FIRST DRIVE: www.edmunds.com You barely even notice the styling changes to the 2010 Ford Mustang GT until you see it side by side with last year’s car. It’s only then that the revised Mustang’s shorter grille, smoother fenders and tucked in rear end become obvious. Look inside and the cabin is the same story. The overall design is familiar, but the details have changed. The materials are richer, the panel fits are tighter and the switchgear feels sturdier. See it all …

Jesse

How much does it cost to repair a 97 Ford Mustang engine?

admin November 22nd, 2009

Miss Tee asked:


A few weeks ago I believe the gaskets in my engine blew out. My Car was overheating. When I tried to cool the engine off by turning the heater on full blast, it only blew out cold air. Finally my car overheated so much it started smoking really badly. I changed my oil and put water and anti freeze. Now my car doesn’t run and rattles. If anyone can give me an accurate generalized estimate of how much it would cost to repair the engine and any other theories on what is wrong with my car. I would totally appreciate it.

Ahmed

1967 Ford Mustang (commercial)

admin November 22nd, 2009

ChargerDaytona asked:


This commercial shows Ford Mustang full-line for 1967, featuring the new cabriolet and hardtop models.

Sheri

2001 Ford Mustang BULLITT w/ Vortech Supercharger

admin November 22nd, 2009

remington723 asked:


2001 Ford Mustang BULLITT w/ Vortech Supercharger

Bettye

Where can i find a used cheap ford mustang? like 90-2004 some where in that model?

admin November 19th, 2009

diorme0223 asked:


I’m looking for an a fordable mustang or dodge dakota because i don’t wanna pay to much for a ”first car”

Cecilia

if you put a fuel injected engine in a 1966 ford mustang. Then put a transmission from a 2006 dodge viper?

admin November 13th, 2009

broncoswr asked:


What is the rpms I am going to get when I shift into 3rd gear before i would need to shift too fourth. What is the gear ratio I am going to be looking at. Would it be good to put a convertable top instead of a hard top.

Gina

what else could be the problem with front end of my Ford Mustang ?

admin November 7th, 2009

tbird64_42420 asked:


i was in car accident about a month ago and it bent and broke the inner tie rod end on drivers side…i put new inner and outter tie rod end on…now while driving it steers to left If i was to let the steering wheel move freely in my hands….

Lamont